Poultry house cleaning protocol between batches: why insect treatment comes first

Nine stages of cleaning a poultry house with the rates set by the current Ukrainian instruction: why lesser mealworm and red mite are treated before the litter cools, two-pass disinfection and a pre-placement checklist.

Poultry house cleaning protocol between batches: why insect treatment comes first

OLEKSANDR SHELYAG, veterinarian, Central Region sales director at WellFarm LLC

Cleaning a poultry house differs from cleaning a pig barn in three ways: litter, insects and stricter regulatory requirements. Each of them changes the order of operations, and the most common mistake is running a poultry protocol on pig-barn logic - which costs you the single most important window for dealing with lesser mealworm and red mite.

Preparing a disinfectant working solution for treating a livestock building
Application rate under the current instruction: 0.5-1.0 L of working solution per square metre for the wet method.

The regulatory frame

Ukraine’s current instruction on sanitary treatment of poultry facilities sets out fairly specific parameters:

  • Application rates: wet method - 0.5-1.0 L of working solution per square metre; aerosol method - 0.3-0.5 L per square metre. A foam method using a foam generator and a gas method at 15-50 °C in a building sealed with film are also provided for.
  • Contact time: from 3-6 hours in standard regimes up to 12-24 hours for spore-forming agents and special cases.
  • Frequency: before every placement in caged systems; twice a year for floor housing with range access; daily after each shift at slaughter facilities; at least once a month at feed mills.

The sequence: nine stages

1. Insect treatment before or immediately after depopulation

This is the step most often put in the wrong place. Insect treatment has to be done while the litter is still warm and the birds are already out. The logic is simple: lesser mealworm (Alphitobius diaperinus) and poultry red mite (Dermanyssus gallinae) migrate out of the cooling litter deep into the structure - into cracks, under insulation, into wall voids. Once they are in there, no treatment will realistically reach them, and they will calmly wait for the next flock.

The scale of the problem is easy to underestimate: in one surveyed poultry house the lesser mealworm population in the litter was estimated at 34.7 million individuals across all life stages. Microbial communities persist in the beetle’s gut for more than five weeks after removal from a contaminated environment - meaning the insect carries pathogens across the downtime between batches, whatever your cleaning achieved. Dermanyssus gallinae can survive in an empty poultry house for up to 10 months.

The rule. Disinsection is the first stage of the clean-out, not the last. Once the litter is out and the temperature has dropped, you are treating empty structures while the population sits in hiding.

Working tools at this stage: TINOKS (water-soluble granules, azamethiphos, low-pressure spraying, also active against insects resistant to organophosphates, effective against Dermanyssus gallinae), BAGSTER EU (emulsifiable concentrate), CHAMELEON FUMIGENO (a cyphenothrin smoke generator that treats the whole volume, voids included).

Diagram: why disinsection in a poultry house must precede litter removal
The window for insect treatment opens the moment the birds leave and closes as the litter cools.

2. Litter and manure removal

Litter goes fully outside the housing zone. Stacking manure right next to the house cancels out everything that follows: it is a source of flies, rodents and pathogens at the same time.

3. Dry cleaning

Top down: ceiling, beams, ventilation ducts, light fittings, air ducts, equipment, walls, floor. Poultry-house dust is a substance of its own - feather debris, manure and feed particles - and it is a reservoir for most pathogens. A house where the floor was washed and the ceiling was never touched has not been cleaned.

4. Dismantling and removing equipment

Nipple lines, feeders, hoppers, nests, cage equipment - everything that comes apart. At the same time the drinking system is drained and put through its own treatment.

5. Soaking

Dried-on manure does not come off under a jet. Low-pressure wetting with a 30-60 minute hold cuts the subsequent wash time several-fold.

6. Foam washing

Applied bottom-up, held 15-30 minutes without drying out.

  • Main chemistry - an alkaline foam detergent: GRASS.
  • Fatty soiling in hard water - chlorinated alkaline: SMV MEGIL.
  • Limescale and mineral deposits, especially on nipple lines and drinkers - an acid cycle: FORMISAN.

7. Pressure washing and drying

Warm water, top down. Problem areas in a poultry house: equipment mounting points, the inner surface of hoppers, augers and feed pipework, ventilation shafts, the space behind insulation, thresholds and door frames.

Drying is not optional: residual water dilutes the disinfectant at the moment of contact.

8. Disinfection in two passes

For a poultry house a two-stage scheme makes sense.

Pass What it covers Product and regime
Wet All accessible surfaces: floor, walls, equipment VIRKON S at 0.5 % for routine work or 1 % when a disease challenge is present; 0.5-1.0 L/m²
Gas or aerosol Volume, voids, ventilation, ceiling, anything a sprayer cannot reach SANIVIR FUMIGENO smoke generator; or aerosol treatment with a 1 % solution at 1 L per 10 m³

Under the current instruction the gas method is carried out in a sealed building at 15-50 °C - and that is not a formality: below 15 °C efficacy drops sharply.

The drinking system is treated in parallel: a shock dose through the empty line followed by a full flush, then continuous dosing during the flock. This is covered in detail in the article on biofilm in drinking water lines; for water, DIXCHLOR, based on chlorine dioxide, is a good fit.

9. Rodent control, downtime and verification

An empty house is the best moment to check and re-bait the perimeter bait stations: PROBLOK (paraffin blocks, moisture-resistant) or NORA PASTA. At the same time, seal gaps and close off entry routes - rodents on poultry sites are a proven reservoir of Campylobacter and Salmonella.

Downtime. Fourteen days is the usual industry minimum between batches. Cutting it under schedule pressure is the most common hidden cause of problems in the following flock.

Verification. Benchmarks for a poultry house: ATP test up to 150 RLU on surfaces; contact plates up to 200 CFU per 25 cm²; swabs up to 100 CFU/cm² for surfaces and up to 1,000 CFU/cm² for floors; Salmonella - zero tolerance.

Why Salmonella survives the clean-out

A Belgian study at slaughter facilities showed that Salmonella can pass through a standard wash-and-disinfect cycle and be carried over to the next batch; the most problematic point was the plucking line equipment, with a prevalence of 17.0 %. The conclusion is broader than the slaughterhouse: where equipment design does not allow it to be properly washed, no disinfectant will save the situation. That is exactly why dismantling and separately washing removable assemblies is a key stage rather than a formality.

Products for sanitary treatment of poultry buildings
Each stage of the clean-out has its own class of product: detergents, disinfectants, insecticides and rodenticides.

Pre-placement checklist

  1. Insect treatment carried out before the litter cooled.
  2. Litter removed outside the housing zone.
  3. Dust cleared from ceilings, beams and ventilation.
  4. Removable equipment washed separately.
  5. Drinking line shock-treated and fully flushed.
  6. Surfaces dry.
  7. Wet disinfection done at the specified rate and contact time.
  8. Gas or aerosol treatment of the volume done at no less than 15 °C.
  9. Bait stations checked and re-charged, gaps sealed.
  10. Downtime observed, verification swabs or ATP test done.
  11. Records completed: date, product, concentration, operator.

Read also

Products for this task are in the Disinfectants section.

The full poultry house sanitation sequence, with products and label rates for every stage from insect control to fumigation, is on the poultry farm biosecurity page.

Sources

  1. Order of the Ministry of Agrarian Policy of Ukraine No. 69 of 20.06.2007, “Instruction on sanitary treatment - disinfection, disinsection and deratisation - of poultry facilities”.
  2. Biology and Management of Lesser Mealworm Alphitobius diaperinus in Broiler Houses. Journal of Integrated Pest Management, 2023; 14(1):2.
  3. Challenges for the Control of Poultry Red Mite (Dermanyssus gallinae). IntechOpen, 2020.
  4. Salmonella persists after cleaning and disinfection - ILVO study, Belgium.
  5. Methods for assessing the efficacy of cleaning and disinfection on livestock farms. Frontiers in Veterinary Science, 2025; 12:1581217.
  6. Meerburg B.G. Rodents are a risk factor for the spreading of pathogens on farms. Veterinary Microbiology, 2010; 142(3-4):464-465.
  7. WellFarm LLC product technical specifications.

Note. Regimes are given for reference. Specific products, concentrations and downtime length are determined by the farm’s technology, the epizootic situation and the instructions of the attending veterinarian.

Share: