Disinfection barriers and foot dips: six reasons they do not work
Why a wheel bath does not disinfect: organic load, contact time, geometry, rainfall, UV and freezing. Working regimes, a comparison with other biosecurity measures and a written inspection routine.
A disinfection barrier is the most visible element of biosecurity. It is what inspectors are shown, what gets photographed for reports and what people mention first when asked what has been done to protect the farm. It is also the element that most often does not work at all - and not because of a poor product, but because of physics and geometry.
In its opinion on African swine fever, the European Food Safety Authority names disinfection of vehicles and entry zones as one of the most common areas of non-compliance in the EU. The problem is systemic, not Ukrainian.

Six reasons a disinfection barrier does not disinfect
1. Organic load
A bath that ten vehicles have driven through is no longer a disinfectant solution but a suspension of dirt with an unknown active concentration. Organic matter binds the active component: for oxidisers this is critical, for phenolics less so - but not indefinitely.
That is why phenolic products such as VIRKON LSP, which are less dependent on organic soiling than peroxygens, make more sense at the entrance. But they too need the solution replaced on a schedule, not on appearance.
2. Insufficient contact time
This is the most underestimated reason. Validated regimes call for minutes: for a wheel bath, around 5 minutes of contact at 1:200 dilution; for a boot dip, at least 1 minute with mechanical cleaning of the sole.
A wheel that crossed the bath in a second received an exposure hundreds of times shorter than required. Part of the answer is geometry: the bath must be longer than the circumference of the wheel, so that the tread makes at least one full rotation in the solution. For a truck with a wheel roughly 1 m in diameter that means a bath of 3.2-4 m or more. A 1.5 m bath treats less than half the tread.
A simple check. Measure the length of your wheel bath and compare it with the circumference of a wheel on the vehicles that typically enter the site. If the bath is shorter, part of the tread never touched the solution at all.
3. Dilution by rain and evaporation
An open bath after rainfall contains an unknown concentration. In hot weather the opposite happens: the solution concentrates and degrades faster. A cover, level control and regular concentration checks solve the problem; without any one of them, what the bath actually delivers is a random variable.
4. Ultraviolet
An open solution in direct sun degrades over the course of a day. Peroxygen products suffer more from this. For outdoor liquid barriers, the manufacturer claims UV stability of phenolic products as a separate advantage - with the caveat that this is a manufacturer’s claim rather than an independently published experiment.
5. Dirt on the sole
A mat under a layer of manure disinfects nothing - it simply moves dirt around. The “1 minute” regime for a boot dip assumes mechanical cleaning of the sole with a brush before immersion. Without a brush at the entrance, a minute of contact achieves nothing: the solution never reaches the surface of the boot.
6. Freezing
Ice in the bath means no barrier for several winter months - precisely when epizootic pressure is highest. Options: heating the bath, moving the barrier into a heated room, switching to dry disinfection with powder products, or abandoning the liquid barrier in favour of changing footwear.

What works better than a disinfection barrier
An uncomfortable point has to be made here: in the hierarchy of biosecurity measures, a liquid barrier is far from first.
| Measure | Evidence |
|---|---|
| Shower and full change of clothing on entry | In foot-and-mouth disease studies, showering with a full change of clothing completely blocked transmission via personnel. For many other agents, hand washing and a change of clothing were sufficient |
| Double fencing inaccessible to wild boar | Rated by EFSA as the measure with the highest level of certainty for ASF: 66-90 % certainty of reducing outbreak numbers by more than half. Parameters: at least 1.5 m high, at least 1.5 m between rows, fixed to the ground |
| A clear line between “clean” and “dirty” zones | The basic principle: everything outside the perimeter is treated as dirty, and every crossing goes through a hygiene lock with a change of boots and clothing |
| Vehicle washing before entry | Disinfecting a dirty wheel is impossible in principle - mechanical removal of dirt has to come first |
| Quarantine for incoming stock | The quarantine building is sited at least 1,000 m from the main units; duration is set by the incubation period of the target pathogen |
A barrier makes sense as the last line in a system where fencing, a hygiene lock and a vehicle wash are already working. As a stand-alone measure it mostly produces a feeling of protection.
Working regimes
| Application | Product and dilution | Contact | Solution change |
|---|---|---|---|
| Wheel bath, vehicle barrier | VIRKON LSP 1:200 | 5 min | On schedule or when visibly soiled |
| Boot dip, disinfection mat | VIRKON LSP 1:200 or VIRKON S 1 % | 1 min with a brush | Daily or when soiled |
| Barrier during an outbreak | VIRKON LSP 1:100 | as prescribed by the veterinarian | Daily |
| Treating bodies, chassis, machinery | VIRKON LSP 1:200 | to full wetting | - |
The advantage of a peroxygen product in a bath is its built-in indicator: the pink colour disappears once the solution is spent. That answers the question “is it still working?” without a laboratory. The nominal service life is up to 7 days, but with heavy traffic the colour goes much sooner - and it is the loss of colour, not the calendar, that signals replacement. A practical rule for a busy dip: renew every 4-5 days or earlier.
The routine worth putting in writing
- A named person responsible for checking the barriers, appointed by written order.
- Daily check: solution level, colour (for products with an indicator), visible soiling, presence of a brush.
- A replacement schedule with the date, product and concentration recorded in a log.
- Vehicle washing before entering the site - mandatory, not at the driver’s discretion.
- A winter routine: heating, covering, or an alternative method.
- A physical, not declarative, ban on walking around the barrier: a narrow passage, fencing, a turnstile.
The last point is decisive. A barrier that can be walked around will be walked around. That is a design question, not a discipline question.
Read also
Products for this task are in the Disinfectants section.
During an outbreak the barrier solution is strengthened, for example VIRKON LSP is used at 1%: the steps and regimes are set out on the outbreak disinfection page.
Sources
- EFSA Panel on Animal Health and Welfare. African swine fever and outdoor farming of pigs. EFSA Journal, 2021; 19(6):6639.
- Alarcón L.V., Allepuz A., Mateu E. Biosecurity in pig farms: a review. Porcine Health Management, 2021; 7:5.
- Center for Food Security and Public Health, Iowa State University. Disinfection 101: Key Principles of Cleaning and Disinfection.
- LANXESS. Virkon® LSP - dilution rates for wheel and boot dips, DEFRA approval.
- Dalton Supplies. Virkon S User Guide, 2024 - solution renewal intervals for disinfection baths.
- Biocheck.UGent. About Biosecurity - the structure of external and internal biosecurity.
Note. Regimes are given for reference. Specific products and concentrations are agreed with the farm’s veterinarian and with the requirements of the State Service for Food Safety and Consumer Protection.
